REDDNet Depot Installation Instructions: Difference between revisions

From ReddNet
Jump to navigation Jump to search
No edit summary
No edit summary
Line 8: Line 8:


#  Unpack the machine, install the rails, and mount in your rack as you normally would.  
#  Unpack the machine, install the rails, and mount in your rack as you normally would.  
#  Plug in network cable to management port.
#  Plug in an ethernet cable to the management port.
#  Plug in appropriate network cables (10 Gb / 1 Gb)
#  Plug in an appropriate network cables to the data ports (depends on whether you are using 10 Gb or 1 Gb)
#  Plug in the REDDNet USB key into a free USB port.
#  Plug in the REDDNet USB key into a free USB port.
#  Plug in power cable.
#  Plug in power cable.
#  Turn on depot.
#  Turn on depot.

Revision as of 16:48, 1 April 2010

Installation instructions

IMPORTANT!!! Do not plug the power cable in until step 5. If you plug the power in before connecting the management network cable, then the IPMI module will not initialize properly and remote management/KVM will not work.

Before you begin, please make sure you have met the basic site requirements

Back of depot
  1. Unpack the machine, install the rails, and mount in your rack as you normally would.
  2. Plug in an ethernet cable to the management port.
  3. Plug in an appropriate network cables to the data ports (depends on whether you are using 10 Gb or 1 Gb)
  4. Plug in the REDDNet USB key into a free USB port.
  5. Plug in power cable.
  6. Turn on depot.